HP INTEGRITY RX3600 - Manual (Page 253)

8. Replace the DVD drive. See “Replacing the DVD Drive” (page 203) .
9. Reconnect the USB cable into the connector on the display board ( Figure 6-30 ).
10. Replace the air baffle ( Figure 6-33 ).
11. Replace the clear plastic cover.
12. Replace the top cover. See
“Replacing the Top Cover” (page 182) .
13. If rack installed, slide the server completely into the rack. See “Inserting the Server into the
Rack” (page 180) .
14. Reconnect the power cables and power on the server. See “Powering On the Server”
(page 94) .
IMPORTANT: Serial number and model string data information is stored on both the
interconnect board and the I/O board. When you install a new interconnect board, you must
copy this information from the I/O board to the new interconnect board.
15. Respond YES to prompts regarding copying information onto the new board.
16. Verify the serial number and model string data information copied onto the new interconnect
board.
a.
Boot to EFI.
b. Enter service mode:
Shell> sysmode service
Current System Mode: ADMIN
You are now in SERVICE mode.
c. Use the sysset command to verify that all values are set:
Shell> sysset
System Information:
Manufacturer: hp
Product Name: server rx3600
Product Number: AB463A
Secondary Product Number is Identical
Serial number: SGH43442VB
Secondary Serial Number is Identical
UUID: 3C33C58E-2E5A-11D8-A33B-4188C0AEFAE2 (Valid)
Secondary UUID is Identical
Product ID: 0x301
Removing and Replacing the Midplane Board
The midplane board is attached to the main bulkhead in the center of the chassis. It provides a
connection between the power supplies, the I/O board assembly, and the processor board
assembly.
WARNING! Ensure that the system is powered off and all power sources have been disconnected
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an ac power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
Removing the Midplane Board
To remove the midplane board, follow these steps:
Removing and Replacing the Midplane Board 253