Stl.exe, Yx.exe, Stl.exe -5 yx.exe -5 – Hand Held Products Dolphin 7200 User Manual
Page 41
6 - 5
/I:
Forces HBCFG.EXE to display 'Please wait Dialog'
Example:
hbcfg /c1 /b57600 /I
If no command line arguments are specified or an error is detected, HBCFG.EXE will open a dialog that allows the user to select
the serial communications port, baud rate, or run a diagnostic.
Note: Dip Switch 2 located on the back of the HomeBase must be set in the Up (PROGRAM) position for the baud rate to be
programmed. The HomeBase power must be cycled (turned off and on) for the new dip switch settings to be recognized.
STL.EXE
STL.EXE is a DOS command line utility for Dolphin that turns the 9th line status indicators on or off.
Usage:
STL [1] [0]
Where:
1:
Turns the status line on
0:
turns the status line off
Example:
STL 1
If no command line is specified, STL.EXE will toggle the status line off, if it was on, and on if it was off.
YX.EXE
YX.EXE is a DOS command line Ymodem communication tool for the Dolphin terminal or a PC.
YX.EXE supports the following options:
Usage:
yx {/c#] [/b#] [/m] [filename]
Where:
filename:
refers to file name to send, if not specified YX will receive a file
/c#:
Specifies COM ports 1-4
(1=Ir Port, 2=Micro DB-9)
/b#:
Specifies new BAUD rate, 300-57600
/m:
Run YX in menu driven mode
Examples:
yx /b57600 autoexec.bat
yx