Hand Held Products Dolphin 7200 - Manual (Page 82)

11 - 4 Dolphin® 7200 User’s Guide
7. At this point, another Condition and Calibrate cycle can be initiated.
Troubleshooting
If you encounter problems with your Dolphin MultiCharger, first, please go through the list of problems and solutions in this
chapter.
If problem persist, please contact Hand Held Products Technical Support.
Problem Issue
The Green/Charging LED does not come
on when I insert a battery pack into the
Dolphin MultiCharger Check the power connections on the Dolphin MultiCharger.
Ensure that the POWER switch is ON and the battery pack is properly
seated.
The Red/Error LED comes on during
charging. Attempt to charge the battery in another pocket location. If the Red/Error
LED follows the battery, then the problem is associated with the battery
pack. If the Red/Error LED stays with the pocket then the problem is
associated with the charging circuitry.
The Red/Error LED remains on, without a
battery in the charging pocket. An error occurred during the self diagnostic test for that particular pocket
location. Refer problem to Hand Held Products Technical Support.