Bottom panel, Baud rate switches, Powering the dolphin terminal – Hand Held Products Dolphin 7200 User Manual
Page 66: Bottom panel -4, Baud rate switches -4, Powering the dolphin terminal -4
9 - 4
Bottom Panel
A Baud Rate DIP switch is located on the bottom of the HomeBase. The three-position DIP switch is used to select the
communication baud rate. Switch position and the corresponding baud rates are shown in the chart below.
Note: The HomeBase Configuration program cannot be used to select the baud rate on the Compact HomeBase.
Powering the Dolphin Terminal
When seated in the HomeBase, the Dolphin terminal receives the power it needs to charge the battery and to run its internal
circuitry.
The Dolphin terminal can be stored indefinitely in the HomeBase without damage to the terminal or the HomeBase. Keep the
HomeBase plugged in so that the Dolphin terminal's battery pack stays fully charged.
Baud Rate Switches
Baud Rate
Switch 1
Switch 2
Switch 3
115200
0
0
0
57600
1
0
0
19200
0
1
0
9600
1
1
0
38400
0
0
1
4800
1
0
1
2400
0
1
1
Baud Rate
Switch