Hamilton Beach Summit Series - Manual (Page 13)

13
Caring for the Blender
Cleaning
The jar should be cleaned immediately
AFTER EACH USE. The jar can be cleaned
in the following manner:
1. Fill the jar half full with warm water,
50 degrees C.
2. Add a drop of liquid detergent or
7.5 mL of detergent powder.
3. Place the cover/filler cap on the jar and
blend on F cycle (factory set profile 5) for
30 seconds.
4. Turn the blender off, and then rinse
the jar and wipe down to dry. Do not
disassemble the cutter assembly.
5. Wash the jar cover/filler cap in warm,
soapy water. Rinse and let dry.
6. Unplug the blender.
7. Wipe down the blender base with a
damp cloth.
8. The Quiet Shield™ may be placed in
the dishwasher for cleaning, however the
high temperatures shorten the life of the
plastic. Handwashing in a three tank
system pot sink (wash, rinse, sanitize) is
recommended for the longest life of these
parts. It is recommended that the shield
be cleaned in the closed position.
w WARNING
Cut Hazard
Always place cover on jar when
blending.
Do not put spoon or other utensils
in jar when blending.
Failure to follow these instructions
can result in broken bones, cuts, or
other injuries.
w WARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
Sanitizing
If the blender will not be used again
within 1 hour, sanitize the container
in the following manner:
1. After washing the jar, fill it with a cold
chlorine-based sanitizing solution that
has a minimum chlorine concentration of
100 parts per million. See recommended
solution below.
2. Place the cover/filler cap on the jar and
blend on F cycle (factory set profile 5) for
a minimum of 2 minutes.
3. Empty the jar but do not rinse.
4. Dry the jar by placing it, with its cover
securely in place, on the blender base
and turn the blender on F cycle (factory
set profile 5) for 2 seconds.
Recommended Sanitizing Solution:
The sanitizing solution should consist of
15 mL of household bleach per 3.8 liters of
clean, cool water (16° C) mixed according
to the instructions on the bleach. When
using a sanitizing solution other than that
recommended, the sanitizing solution con-
centration should be tested using commer-
cially available test strips and should indi-
cate a concentration between 100 and 200
parts per million of bleach to water.
A-840083400B-ENv01 11/30/01 3:57 PM Page 13