Hamilton Beach Summit Series - Manual (Page 4)

4
• Read the operation manual before using
blender. Keep the manual handy.
• Plug into a grounded outlet.
• Do not remove ground.
• Do not use an adapter.
• Do not use an extension cord.
• To reduce risk of personal injury, unplug
cord from outlet when not in use, and
before putting on or taking off parts.
• Do not store any kitchen utensils in the
container since the blender would be
damaged if inadvertently turned on.
• To prevent possibility of serious personal
injury, keep hands out of blender jar while
operating blender. Always operate blender
with jar cover in place.
• Blades are sharp. Handle carefully.
• Inspect jar and cutter assembly daily.
Check cutter for wear, nicks, or broken
blades. Replace jar and cutter assembly
every 12 months, or sooner if cutter
assembly appears worn or damaged.
• Do not defeat the jar pad sensors.
• Do not use outdoors.
• Do not place in or near water or liquids.
• Do not drop or slam the Quiet Shield™.
• Keep fingers away from edges and
joints when opening and closing
the Quiet Shield™.
• Always use the handle to open and
close the Quiet Shield™.
• Only use the Hamilton Beach 32 oz.
(0.95 L) blender container (part number
6126-91515 as provided with the unit).
• Do not strike the container against a
surface to loosen ingredients.
• To reduce risk of personal injury and to
prevent damage to blender or jar and
cutter assembly, DO NOT insert utensils
into blender jar while operating blender.
• To prevent damage to blender, jar, or cut-
ter assembly, DO NOT move or shake
blender while in operation. If blending
action stops during operation, turn blender
OFF, remove jar from base, remove jar
cover, and use a thin rubber spatula to
push mixture towards cutters.
• To prevent burns from hot liquids splash-
ing out of the jar, always remove the filler
cap of the container cover before blend-
ing.
• Do not submerge in liquids or wash the
blender base in a dishwasher.
• Do not spray the base with a high-
pressure spray gun.
• Do not carry the unit by the power cord.
• Disconnect power before cleaning.
• Disconnect power before taking to an
authorized service facility.
• Only authorized service facilities should
repair the blender.
• Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions, or is dropped
or damaged in any manner.
• If the supply cord of this appliance is dam-
aged, it must be replaced by the manufac-
turer or its service agent or a similar quali-
fied person. If fitted with a non-rewirable
U.K. plug, the 13 amp fuse approved by
ASTA to be B.S. 1362 must be used. If
you need a replacement fuse carrier, it
must be replaced by the same colour
coded carrier with the same markings.
Fuse covers and carriers can be obtained
from approved service agents.
IMPORTANT: If the molded plug is cut
off, dispose of it immediately. The plug
is not rewirable and would cause a shock
hazard if inserted into a socket.
Blender Safety
–
SAVE THESE INSTRUCTIONS
–
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using electrical appliances basic safety precautions should be
followed, including the following:
A-840083400B-ENv01 11/30/01 3:57 PM Page 4