Helpful tips & suggestions, Storing your engine, Adding a gasoline stabilizer – HONDA GC190 User Manual

Page 7: Draining the fuel tank and carburetor, Warning

Advertising
background image

7

E

HELPFUL TIPS & SUGGESTIONS

STORING YOUR ENGINE
Storage Preparation

Proper storage preparation is essential for keeping your engine
trouble-free and looking good. The following steps will help to keep
rust and corrosion from impairing your engine’s function and
appearance, and will make the engine easier to start when you use it
again.

Cleaning

If the engine has been running, allow it to cool for at least half an hour
before cleaning. Clean all exterior surfaces, touch up any damaged
paint, and coat other areas that may rust with a light film of oil.

NOTICE

Using a garden hose or pressure washing equipment can force water
into the air cleaner or muffler opening. Water in the air cleaner will
soak the air filter, and water that passes through the air filter or muffler
can enter the cylinder, causing damage.

Fuel

Gasoline will oxidize and deteriorate in storage. Deteriorated gasoline
will cause hard starting, and it leaves gum deposits that clog the fuel
system. If the gasoline in your engine deteriorates during storage, you
may need to have the carburetor, and other fuel system components,
serviced or replaced.

The length of time that gasoline can be left in your fuel tank and
carburetor without causing functional problems will vary with such
factors as gasoline blend, your storage temperatures, and whether
the fuel tank is partially or completely filled. The air in a partially filled
fuel tank promotes fuel deterioration. Very warm storage
temperatures accelerate fuel deterioration. Fuel problems may occur
within a few months, or even less if the gasoline was not fresh when
you filled the fuel tank.

Fuel system damage or engine performance problems resulting from
neglected storage preparation are not covered under the Distributor’s
Limited Warranty
(see page 11).

You can extend fuel storage life by adding a gasoline stabilizer that is
formulated for that purpose, or you can avoid fuel deterioration
problems by draining the fuel tank and carburetor.

ADDING A GASOLINE STABILIZER TO EXTEND FUEL
STORAGE LIFE

When adding a gasoline stabilizer, fill the fuel tank with fresh gasoline.
If only partially filled, air in the tank will promote fuel deterioration
during storage. If you keep a container of gasoline for refueling, be
sure that it contains only fresh gasoline.

1. Add gasoline stabilizer following the manufacturer’s instructions.

2. After adding a gasoline stabilizer, run the engine outdoors for 10

minutes to be sure that treated gasoline has replaced the
untreated gasoline in the carburetor.

3. Stop the engine.

DRAINING THE FUEL TANK AND CARBURETOR

1. Use a siphon pump (commercially available) and siphon the fuel

out of the fuel tank into an approved gasoline container.

2. Place an approved gasoline container below the carburetor, and

use a funnel to avoid spilling fuel.

3. Loosen the carburetor drain screw. and drain the carburetor into an

approved gasoline container. After draining is completed, tighten
the carburetor drain screw.

Engine Oil

1. Change the engine oil

(see page 5).

2. Remove the spark plug

(see page 6).

3. Pour a tablespoon

(5 - 10 cc) of clean engine
oil into the cylinder.

4. Pull the recoil starter several

times to distribute the oil.

5. Reinstall the spark plug.

Storage Precautions

If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water heater,
or clothes dryer. Also avoid any area with a spark-producing electric
motor, or where power tools are operated.

If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.

Keep the engine level in storage. Tilting can cause fuel or oil leakage.

With the engine and exhaust system cool, cover the engine to keep
out dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use sheet plastic as a dust cover. A nonporous
cover will trap moisture around the engine, promoting rust and
corrosion.

WARNING

Gasoline is highly flammable and explosive, and you can
be burned or seriously injured when handling fuel.
• Stop engine and keep heat, sparks, and flame away.
• Refuel only outdoors.
• Wipe up spills immediately.

SIPHON PUMP
(COMMERCIALLY
AVAILABLE)

FLOAT BOWL

DRAIN SCREW

POM53483-D.book Page 7 Thursday, March 17, 2005 4:42 PM

Advertising