Hitachi SINGLE-BAND PCS PHONE SH-P300 - Manual (Page 36)

Section 2: Understanding Your Phone
27 2A: Your PCS Phone – The Basics
Answering Calls
1. Make sure your phone is on. If your phone is off, incoming calls go to
voicemail.
2. When a call comes in, answer the call by pressing
T. Depending
on your settings, your PCS Phone notifies you of incoming calls in the
following ways:
ᮣ The phone rings and/or vibrates.
ᮣ The LED flashes.
ᮣ The backlight illuminates.
ᮣ The screen displays an incoming call message and animation.
ᮣ If available, the phone number of the caller is displayed.
ᮣ If the phone number is in your Internal Phone Book, the Phone Book
entry’s name is displayed.
You can perform the following when you have an incoming call.
ᮣ Press
T to answer incoming calls.
ᮣ Press
E to put the caller on hold.
ᮣ Move the cursor key upward or downward to change the ringer volume.
ᮣ Press
E twice very quickly to cancel the call.
Depending on your settings, you may also answer incoming calls by
pressing any digit. (To answer a call when you are roaming and Call
Guard is enabled, you must press
to answer the call. See
“Controlling Roaming Charges Using Call Guard” on page 59.)
Note: If your phone is off, incoming calls go to voicemail.
3. To disconnect the call, press
E.
OK