Test the installation, Hpweb jetadmin, Test the installation hp web jetadmin – HP 3100C User Manual
Page 25: Hp web jetadmin
24
Test the installation
Use the following steps to verify the digital sender setup.
To test the installation
1
Display the Revision page to verify that the network interface card
is successfully linked to the network. The TCP/IP status
parameter should read
READY
. To display the page, select
S
TATUS
(
A
LT
+
F3
), then
R
EVISION
(
F1
). Press
B
ACK
(
F4
) to close.
2
Test the e-mail service to confirm that the digital sender can
communicate through Internet e-mail. See the user guide for
instructions on sending e-mail. Be sure to type your address in
the To field.
3
Test the Internet fax service by sending a test fax to a local fax
number. See the user guide for instructions on sending faxes.
4
Test the print function by sending a document to a HP JetSend-
enabled printer. See the user guide for instructions on sending to
a printer.
HP Web JetAdmin
HP Web JetAdmin is an optional utility for use with the digital sender.
It is a browser-based program that lets you remotely configure,
monitor, and control HP network peripherals such as printers,
plotters, scanners, and digital senders. Download the HP Web
JetAdmin software from the HP digital sender website
(