Harman-Kardon WMS 470 - Manual (Page 37)

3 General
17 - 20, 22: Refer to section "Handheld Transmitter".
25 Antenna: Permanently connected, flexible antenna.
26 Audio input: 3-pin mini XLR connector with both mic and line level pins that automat-
ically match the connector pinout of the recommended AKG microphones (optional) or
supplied MKG L instrument cable.
You can connect AKG microphones with a mini LXLR connector to the audio input on the
bodypack transmitter:
The MKG L instrument cable lets you connect an electric guitar, electric bass, or remote
keyboard to the bodypack transmitter.
For further details, refer to the respective AKG brochures.
27 Frequency sticker: Sticker attached to the transmitter shaft, indicating the available
carrier frequency range and approval data.
28 Battery compartment for the supplied AA size 1.5 V dry battery or a commercial
1.2 V, ≥2100 mAh NiMH AA size rechargeable battery. The viewing window lets you
check if there is a dry or rechargeable battery inside the battery compartment. You can
also insert a white lettering strip (supplied) or a color code strip (optional) into the view-
ing window.
29 Belt clip for fixing the transmitter to your belt.
30 MUTE jack: This jack allows you to connect either the optional Remote Mute switch or
the supplied terminal connector for locking the ON-MUTE/PRG-OFF switch to prevent op-
erating errors.
31 Gain control: This rotary control inside the battery compartment allows you to match the
bodypack transmitter input gain to the microphone or instrument you connected to the
transmitter.
Bodypack Transmitter
Refer to fig. 4 on page iv.
31 WMS 470
WMS470_F031016_Hex_final 22.12.2010 14:19 Uhr Seite 31 (Schwarz/Black Auszug)