HP 16V User Manual
Page 2
Notice to American
Users
Federal Communications Commission
Radio Frequency Interference Statement
Notice to Canadian
Users
Notice to German
Users
Notice to Japanese
Users
User’s Manual
Notice:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
l
Consult the dealer or an experienced radio / TV technician for help.
FCC warning:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Notes
l
Testing of this equipment was performed on model number M33101 AS01.
l
The use of a non-shielded interface cable with the referenced device is prohibited.
The length of the parallel interface cable must be 3 meters (10 feet) or less. The
length of the serial interface cable must be 15 meters (50 feet) or less.
l
The length of the power cord must be 3 meters (10 feet) or less.
laser Safety Information
This printer has been designed and manufactured according to FDA regulations
“title 21, CFR, chapter I, subchapter J, based on the Radiation Control for Health
and Safety Act of 1968”, and is classified as class 1 laser product.
Warning:
Use of controls, adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
This class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la Classe
le materiel brouilleur du Canada.
B respecte toutes les exigences du Réglement sur
FM- 1