HP 2420 - Manual (Page 198)

Paper size
The width and height values can be changed by typing numeric strings into the edit boxes in the
Paper Size group box.
Any entry that is greater than the maximum limits of the width and height control is rounded down to
the maximum valid entry, while any entry that is smaller than the minimum limits of the width and
height control is rounded up to the minimum valid entry.
Any non-numerical entry reverts to the last valid entry. Width and height entries are validated when
the focus has changed.
The resolution of the control is two decimal places for both millimeters and inches.
Units
To change measurement units, select one of the radio buttons in the Units group box (either Inches
or Millimeters).
Custom width and height control limits
The minimum media size for the HP LaserJet 2410, 2420, and 2430 printer is 76.2 x 127 mm (3 x 5
inches) and the maximum is 215.9 x 355.6 mm (8.5 x 14 inches). The following table summarizes
media size limits for each media-handling device.
Table 4-2 PCL 6 custom media sizes
Tray Dimensions Minimum Maximum
Tray 1 (multipurpose) Width 76.2 mm (3 inches) 215.9 mm (8.5 inches)
Height 127.0 mm (5 inches) 355.6 mm (14 inches)
Tray 2 (250-sheet) Width Custom sizes not supported Custom sizes not supported
Height Custom sizes not supported Custom sizes not supported
Tray 3 (500-sheet) Width Custom sizes not supported Custom sizes not supported
Height Custom sizes not supported Custom sizes not supported
Duplexing unit Width Custom sizes not supported Custom sizes not supported
Height Custom sizes not supported Custom sizes not supported
Use Different Paper/Covers
When the Use Different Paper/Covers check box is selected and different options are configured,
the Size is:, Source is:, and Type is: menus change, offering a variety of options. For more
information, see the
Use Different Paper/Covers section in this chapter of the guide.
Source Is
The Source is: setting specifies the source tray to use for printing a document. The list of source
trays depends on the product accessories. Any optional source trays that are installed through the
Device Settings tab also appear here.
182 4 HP PCL 6, HP PCL 5e, and HP PS 3 emulation unidrivers for Windows
HP unidrivers