Honeywell HW2000i - Manual (Page 18)

Starting Generator
12 www.honeywellgenerators.com HW1000i / HW2000i Inverter Generator Owner’s Manual
Starting Generator
Starting Generator
1. Fill the fuel tank and check oil is to appropriate level.
NOTE:
The generator starts more easily with a full fuel tank.
2. Place the generator outside on a flat surface free of
debris to prevent blocking the air intake vents in the
bottom of the generator.
3. Connect a ground wire to the generator (see “Ground-
ing the Generator” on page 6).
4. Move the choke to the ON position.
NOTE:
Place the choke in the OFF position when the HW1000i
has a warm engine.
5. Set the efficiency mode switch to the OFF position.
6. Turn the fuel valve to the ON position.
7. Press the engine control switch to the RUN position.
8. HW1000i Model Only: Turn the fuel cap vent to the
ON position.
Before starting generator, be sure to thoroughly read
all information provided in this Owner’s Manual.
NOTICE
It is very important to maintain the proper level of engine oil
to keep the engine in good running condition.
• Check engine oil level prior to each use.
IMPORTANT! BEFORE STARTING GENERATOR, FILL
WITH ENGINE OIL.
Starting generator with appliances connected can cause
permanent damage to appliances.
• NEVER start generator with electrical appliances
plugged in and turned on.
• Do not move the generator while it is running.
FIGURE 6: Air Intake - DO NOT BLOCK
NOTICE
Blocking the air flow may cause damage to the generator.
WARNING
FIGURE 7: Efficiency Mode Switch
FIGURE 8: Fuel Valve — ON position
FIGURE 9: Engine Control Switch
FIGURE 10: Fuel Cap Vent — ON position
OFF
ON
FUEL
p/n 101592A ON
OFF
ON