Hitachi DZ-GX5040E - Manual (Page 136)

English
136
*1
•
This message may also appear when dirt adheres to disc. If this message appears when a recorded
disc is recognised immediately after it is inserted, do not repair the disc; remove it and then use the
provided disc cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not repair the disc; turn
the DVD video camera/recorder off, wait until it dries out, and then turn it on again.
• If the repair message appears when you turn the DVD video camera/recorder on from off with a
disc loaded after recording on it, choose repair.
• If the repair message appears when recording and playback are normally possible with another
disc – and no condensation occurs and the disc is not dirty – choose repair.
*2
•
This message may also appear when dirt adheres to disc. In this case, do not initialise the disc:
Remove it and then use the provided disc cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not initialise the disc;
turn the DVD video camera/recorder off, wait until it dries out, and then turn it on again.
• Initialisation will delete all data on disc.
This disc cannot be
used. Please replace
disc. A disc that cannot be used on this DVD video camera/recorder
has been loaded. Check the type of disc.
26
This disc is finalized.
Finalize is not required. This message will appear if you press the FINALIZE button with a
finalised DVD-RW/DVD-R/+RW loaded in this DVD video camera/
recorder. Finalising the disc is not necessary.
103
This disc is recorded by
the NTSC system.
Please replace disc. This DVD video camera/recorder can use only discs recorded on
the PAL system. A disc recorded on the NTSC system cannot be
used on this DVD video camera/recorder.
—
UNFORMAT DISC The disc is not initialised or it is damaged.
If this message appears, be sure to initialise the disc on this DVD
video camera/recorder before using it.
Reinitialising even a disc used on this DVD video camera/
recorder may be necessary (initialising will erase all recorded
contents on disc). If this message appears, try to initialise the
disc. If the same message still appears, the disc may be
damaged: Use another disc.
100
See *2 on this page. 11
Use AC adapter/
charger. Finalisation is not possible when the DVD video camera/recorder
is powered by a battery: Use the AC adapter/charger for
finalisation.
27, 103
Use AC adapter/
charger.
Turn off power. Scene cannot be repaired when the DVD video camera/recorder
is powered by a battery.
If the AC adapter/charger is unavailable in handy place, remove
the disc, use the opposite side, or use another disc. To repair the
removed disc, insert the disc into the DVD video camera/recorder
afterwards, and connect the AC adapter/charger.
27
Write protected.
Check card. A card with the erase prevention switch locked is inserted: Unlock
the switch.
26
Write protected.
Check disc. • A write-protected disc is inserted.
• Release the write-protect using the Disc Navigation menu.
101
Message Cause & Troubleshooting
Reference
page