Installing, Receiver location, Optional external equipment – HP PL5000N User Manual

Page 15: Installing remote control batteries

Advertising
background image

Installing

Installing

7

Installing

Receiver Location

This unit is intended to be used with the stand. Consult
your dealer for available options. Position for
comfortable viewing. Avoid placing where sunlight or
other bright light (including reflections) will fall on the
screen.

Use of some types of fluorescent lighting can reduce
remote control transmitter range.

Adequate ventilation is essential to prevent internal
component failure. Keep away from areas of excessive
heat or moisture.

Optional External
Equipment

The video and audio connections between components
can be made with shielded video and audio cables.
For best performance, video cables should utilize
75-ohm coaxial shielded wire. Cables are available
from your dealer or electronic supply store.

Before you purchase any cables, be sure you know
what type of output and input connectors your various
components require. Also determine the length of
cable you will need.

Installing Remote Control
Batteries

1

Open the cover.

2

Install the batteries and replace the cover.

Note the correct polarity (+ and –).

n

Replace used batteries with alkaline
batteries for longer life.

c

CAUTION: Incorrect installation can cause
battery leakage and corrosion that will damage
the remote control transmitter.

Observe the following precautions:

Batteries should always be replaced as a set.
Always use new batteries when replacing the
old set.

Do not combine a used battery with a new one.

Do not mix battery types (example: “zinc
carbon” with “alkaline”).

Do not attempt to charge, short-circuit,
disassemble, heat, or burn used batteries.

Battery replacement is necessary when
remote control acts sporadically or stops
operating the TV set.

When not using the remote for a long period of
time, remove the batteries to prevent damage
or injury from possible battery leakage.

Do not try to recharge batteries that are not
intended to be recharged: they can overheat
and rupture. Follow the battery manufacturer’s
directions for the batteries you are using.

mb5pohtv.book Page 7 Wednesday, July 6, 2005 9:52 AM

Advertising
This manual is related to the following products: