High End Systems Technobeam - Manual (Page 105)

4-6 Creating a Scene Technobeam
®
User Manual
11. If the flags are closed, repeat this procedure.
12. If the shutter is open and no light is exiting the fixture, the lamp is off.
(The lamp is automatically turned off after a period of no activity.) In
that case, turn the fixture OFF, wait a few minutes, then repeat the
procedure in the section titled “Turning on the Lamp” on page 4-4.
Positioning the Mirror
1. Use the <Up> and <Down> arrow keys to navigate to the PAN
construct.
2. Use the <Up> and <Down> arrow keys to move the mirror to the
desired location, then press <Enter>.
3. Use the <Up> and <Down> arrow keys to navigate to the TILT
construct and press <Enter>.
4. Use the <Up> and <Down> arrow keys to move the mirror to the
desired location, then press <Enter>.
Focusing on a Litho
1. Use the <Up> and <Down> arrow keys to navigate to the LTOC (control)
construct.
2. Press <Enter>, then use the <Up> and <Down> arrow keys to select
IDX
.
3. Press <Enter> to accept your selection, then use the <Up> and <Down>
arrow keys to navigate to the LTO construct.
4. Press <Enter>, then press the <Up> or <Down> arrow keys to select any
litho pattern (except L 1, the open position).
5. Press <Enter> to accept your selection, then use the <Up> and <Down>
arrow keys to navigate to the FCUS construct.
6. Press <Enter>, then use the <Up> and <Down> arrow keys to bring the
litho into sharp focus.
7. Press <Enter> when you are finished focusing the fixture.
Selecting Color Wheel Constructs
1. Use the <Up> and <Down> arrow keys to select COLC.
2. Press <Enter>, then press the <Up> and <Down> arrow keys to select
RND
(random color selection).
3. Press <Enter>. The color wheel spins and stops on a random position,
pausing for a length of time you will set in the next section.