Honeywell EQUIP HD3MDIHX - Manual (Page 36)

36
Installing the Honeywell IP Utility and Web-Client Software
The IP network setting details, such as device name, IP address, and subnet mask, can be
configured for each connected device either automatically or manually.
Note It is important to click Apply to save any configuration change.
Figure 3-4 Set the IP Network Settings Automatically or Manually
Table 3-4 IP Network Device Setting Options
Option Description
Device Name By default, the device name is the device type plus the MAC Address. Honeywell
recommends, for security, that you change the device name.
MAC Address The MAC address is a factory-assigned address that is unique for each device.
IP Address The IP address of the device on the network.The camera obtains an IP address
by static or dynamic (automatic) means. There are two options: DHCP (dynamic),
assigned by the user, or APIPA (static), assigned by the network.
Subnet Mask The subnet mask, or netmask, value of the device on the network. IP networks
can be divided into several smaller networks by subnetting. When a network is
subnetted, you must specify a subnet mask, which tells network devices which
smaller network they belong to.
Note If the subnet mask is not properly configured, the camera might not be
able to communicate with other devices on the network.
Default Gateway The default gateway address that connects the device to the network. Enter the
host IP address to use as a gateway between networks. The gateway allows
communication between devices that are on different networks. Without a correct
gateway setting, the camera cannot receive or transmit data from or to devices
that are not in the same network address range.
Click to clear this checkbox to
manually set the network details