Humax HDCI-2000T - Manual (Page 52)

10. Installation
In this chapter you can configure the installation settings in automatic search and manual search and update the
software. You can also initialize the setting to the factory default.
**
Note: Press the BACK button to save the changes and return to the previous menu. Press the MENU
button to exit the menu screen.
10.1 Automatic Search
If your product is connected to the aerial and TV, you can search channels automatically without entering additional
information.
1. Press the MENU button.
2. Select Installation using the button and press the OK
button.
3. Select Automatic Search from Installation menu using the
button, and press the OK button.
1. Search
Wait while channel search continues. This may take a few minutes.
When you select Stop during channels search, the search will
discontinue and the accumulated search results will show. If there is no
channel available, a message indicating the result will pop up. Activate
the search again if necessary.
To save the search results, select Save and press the OK button.
10. Installation
GB 51