Hand Held Products HANDHELD 3800G - Manual (Page 41)

3800g User’s Guide 3 - 9
Other Programming Selections
• Discard
This exits without saving any Output Sequence changes.
Output Sequence Editor
Require Output Sequence
When an output sequence is Required , all output data must conform to an edited
sequence or the imager will not transmit the output data to the host device.
When it’s
On/Not Required , the imager will attempt to get the output data to
conform to an edited sequence, but if it cannot, the imager transmits all output
data to the host device as is.
When the output sequence is Off , the bar code data is output to the host as the
imager decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Output Sequence Example
In this example, you are scanning Code 93, Code 128, and Code 39 bar codes,
but you want the imager to output Code 39 1st, Code 128 2nd, and Code 93 3rd,
as shown below.
Enter Sequence
Default Sequence
Required
On/Not Required
* Off