HP 330 - Manual (Page 158)

10–8
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 10–8 (seq: 158)
This is the black on page 10–8 (seq: 158)
Interface specifications
Below are the parallel and serial interface specifications. On the following page
are the pin configurations for the most common HP cables referenced on page
10–11.
Parallel (Bi-Tronics/Centronics)
Interface Pin Wire/Signal Name Source
Interface
The connector on the plotter is 36 pin
1 Strobe computer
The connector on the plotter is 36-pin
female.
2 ... 9 D0 ... D7 (data lines) both
Most existing parallel cables support
11 Busy plotter
Most existing arallel cables su ort
Bi-Tronics communication, but, for use
12 PError plotter
with this plotter, the cable must meet
the specification in this table
13 Select (SelectOut) plotter
the s ecification in this table.
IEEE ibl
14 AutoFd computer
IEEE-1284-compatible.
16 GND
19 ... 30 GND
31 Init computer
32 Fault plotter
36 SelectIn computer
Serial (RS-232-C) Interface Pin Wire/Signal Name Source
The connector on the plotter is 25 pin
1 Protective Ground
The connector on the plotter is 25-pin
female.
2 Transmitted Data DTE
The plotter is configured as DTE (data
3 Received Data DCE
The lotter is configured as DTE (data
terminal equipment).
4 Request to Send DTE
q )
Data is transmitted on Pin 2 and
6 Data Set Ready DCE
Data is transmitted on Pin 2 and
received on Pin 3.
7 Signal Ground
20 Data Terminal Ready DTE
Localization Note. Identical to Loquillo 750C UG p11-7 (except for page reference in first
paragraph, IEEE–compatibility note and bleeding tab).
Reference
Interface specifications