HP 330 - Manual (Page 36)

1–22
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 1–22 (seq: 36)
This is the black on page 1–22 (seq: 36)
An example of a Setup Sheet is shown on the previous page. That example is for
an E/A0-size plotter. The items in the Setup Sheet are listed in the table below.
Setup Sheet Items and Defaults
Item
Factory
Default
Comments
Language English Task 6 explained how to change this.
Baud Rate 9600 (Serial interface only). You must set the baud
rate to be the same as that of the computer
sending the data.
Parity None (Serial interface only). You must set the parity to
be the same as that of the computer sending the
data.
Graphics
Language HP-GL (7586B) See page 6–3.
I/O Timeout 30 min See page 6–4.
Rotate off See page 3–7
Mirror off See page 3–10
Merge off See page 3–11
Color/Mono Print color as
color See page 3–13
Page Size Inked Area See page 3–5.
Note that not all the page size options shown in
the example are available on the D-size plotter.
Pen Settings Use settings
from software See page 3–12.
Note that the color pen settings
are only available on the
HP DesignJet 350C.
Localization Note JKCT: Similar to Parrot UG p 1–28.
Setting up your plotter
Task 8: (Optional) Configure the plotter
350C
350C