HP 330 - Manual (Page 86)

350C
330
3–14
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 3–14 (seq: 86)
This is the black on page 3–14 (seq: 86)
Important points about monochrome printing
The monochrome plot will render colors as grayscales. If you want your plot
printed in only black and white, then you should set all your logical pens to
black, either in your software (easily achieved in CAD software by using a pen
number that is 100% black) or in the Setup Sheet (see page 3–12).
With monochrome plotting, you have the option to choose between 300 and 600
dpi resolution (see page 3–15).
– With the HP DesignJet 350C, the resolution on glossy media is always 300
dpi. This is because, with the
Glossy media type selected, all printing is
performed using the cyan, yellow and magenta cartridges; the black cartridge is
not used.
– With the HP DesignJet 330, glossy media is not supported.
Printing color drawings in monochrome
Controlling your plot’s appearance
Localization Note. .Treat as new.