Connection to a tv (for video) – Hitachi DVP725U User Manual
Page 14
– 14 –
EN
1L01
CONNECTION TO A TV (FOR VIDEO)
DVD
Analog Audio out
Video out
• Method 1 DVD Player + TV with Video Input Jack
• Method 2 DVD Player + TV with S-Video Input Jack
• Method 3 DVD Player + TV with Component Video Jacks
S-VIDEO
OUT
COMPONENT
VIDEO OUT
ANALOG
AUDIO OUT
Y
C
B
/P
B
C
R
/P
R
R
L
VIDEO
OUT
C
B
Y
C
R
R
L
S-VIDEO IN
COMPONENT
S-VIDEO IN
VIDEO IN
or
or
or
P
B
Y
P
R
TV
Method 1
Good picture
Basic Audio
Method 2
Method 3
Better picture
Best picture
S-Video out
Component Video out
AV Cable
S-Video
Cable
Video
Cables
Notes
¡
If your TV is compatible with progressive scanning (480p), connect the TV to the Component Video Output
jacks of the DVD player. Refer to page 12.
¡
Connect the DVD player directly to a TV. If the A/V cables are connected to a VCR, pictures may be
distorted due to the copy protection system.
HOW TO CONNECT TO A TV WITHOUT AUDIO/VIDEO INPUT JACKS
If your TV does not have RCA type audio and video input jacks it is still possible to connect this DVD
player to your TV’s 75-ohm coaxial antenna terminal using a commercially available Stereo Audio/Video RF
Modulator, not included. Connect the audio and video outputs of the DVD player to the audio and video inputs
on the RF Modulator, and then connect the coaxial output of the RF Modulator (usually marked “TO TV”) to
the 75 ohm coaxial antenna terminal on your TV. Follow the instruction supplied with the RF Modulator for
more details.
If your TV’s 75 ohm coaxial antenna terminal is already occupied by an antenna or cable box connection,
remove that cable from your TV’s antenna terminal and reconnect it to the coaxial antenna input terminal
of the RF Modulator (usually marked “ANT IN”), then connect the RF modulator to your TV’s antenna
terminal as described above.
Note
¡
The picture quality from DVD discs will not be as good if the DVD player is connected to the TV’s
antenna terminal through an RF Modulator.
E5615.QX3 02.4.15 0:00 PM Page 14