Hitachi DVP725U - Manual (Page 30)

– 30 – EN
1L01
CONTROLLING THE TV
Once programmed, the DVD’s remote control is
ready to control the TV.
NOTE: Be aware that not all of your TV’s functions
may work even though the remote control is
correctly programmed.
To operate the TV
¡ You can turn on your TV by pressing the TV
POWER button.
¡ You can change the channels with the CH ( K ) or
CH ( L ) button and the volumes with VOL ( ) or
VOL ( ) button for the TV.
To operate the DVD
Press the VIDEO/TV button to operate your DVD
with the remote.
PROGRAMMING THE REMOTE
CONTROL OF THE TV
1 Turn off the TV .
2 Program the remote control
Aim the DVD’s remote control at your TV set. Hold
down the TV POWER button while you press the
number corresponding to your brand of television as
shown in the chart.
For example; If you have a Hitachi television, press
the TV POWER and 1 at the same time. If this but-
ton combination sends a signal that matches with
your TV, the TV will turn on, and you’ll know the
remote is set to control the television.
NOTES:
¡ If that button combination does not change the TV
channel, go through the whole list of button combi-
nations one by one until you find one that does
change your TV channel.
¡ Also, if your brand of TV is not listed in the chart,
try all the number buttons. One of them may work
for you.
¡ If the TV channel still doesn’t change after going
through all the button combinations listed, it is
likely that you will not be able to program this
remote control for your TV.
REMOTE CONTROL OF THE TV
TV Brands Press the TV and This Number
HITACHI 1
SONY 2
RCA 3
SANYO 4
ZENITH 5
PANASONIC1 6
PANASONIC2 7
SHARP1 8
SHARP2 9
TOSHIBA 0
JVC CLEAR
MITUBISHI +10
MAGNAVOX SUBTITLE
FUNAI AUDIO
GOLDSTAR DISPLAY
E5615.QX3 02.4.15 0:00 PM Page 30