HONDA 2011 Pilot - Manual (Page 178)

Fail to press a memory button
within 5 seconds.
To cancel the storing procedure
after pressing the SET button, do
any of the following:
Pressing the SET button again
within 5 seconds.
Readjusting the outside mirror
position.
Readjust the seat position.
To select a memorized position, do
this:
Make sure the shift lever is in the
Park (P) position.
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
All stored driving positions will be
lost if your vehicle’s battery goes
dead or is disconnected.
The system will move the seat and
outside mirrors to the memorized
positions. The indicator in the
selected memory button will flash
during movement. When the
adjustments are complete, you will
hear two beeps, and the indicator will
remain on.
1.
2.
Driving Position Memory System
Selecting a Memorized Position
174
10/01/26 18:53:11 31SZA620_179
2011 Pilot