Parking sensor system, rearview camera and monitor – HONDA 2011 Pilot User Manual

Page 394

Advertising
background image

For the best picture, always keep the
rearview camera clean, and do not
cover the camera lens. To avoid
scratching the lens when you clean it,
use a moist, soft cloth.

Since the rearview camera display
area is limited, you should always
back up slowly and carefully, and
look behind you for obstacles.

When the system is affected by
some electrical equipment or
devices generating an ultrasonic
wave.

When operating the vehicle in bad
weather.

The system may not sense thin or
low objects, or sonic-absorptive
materials such as snow, cotton, or
sponge.
The system cannot sense objects
directly under the bumper.

Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rear view is shown
on the navigation system screen. On
vehicles without a navigation system,
the rear view is shown on the left
side of the inside mirror.

This device complies with Industry
Canada Standard RSS-210. Operation is
subject to the following two conditions:
(1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.

Canadian Owners:

This ISM device complies with Canadian
ICES-001.

On EX-L and Touring models

Parking Sensor System, Rearview Camera and Monitor

Rearview Camera and Monitor

390

10/01/26 19:30:23 31SZA620_395

2011 Pilot

Advertising
This manual is related to the following products: