HONDA 2011 Pilot - Manual (Page 81)

This indicator comes on when there
is a system message on the multi-
information display. Press the INFO
button on the steering wheel (see
page
) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
This indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It
reminds you that it is time to take
your vehicle in for scheduled
maintenance. The maintenance main
items and sub items will be displayed
in the information display. See page
for more information on the
maintenance information.
This indicator goes off when your
dealer resets it after completing the
required maintenance service.
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. If it comes on at any other
time, there is a problem in the 4WD
system. Take the vehicle to your
dealer to have it checked.
If the indicator blinks while driving,
the VTM-4 fluid temperature is too
high. Pull to the side of the road
when it is safe, shift to Park, and let
the engine idle until the indicator
goes out. 455
87
94
On vehicles with navigation system On vehicles without navigation system 4WD models only
Message Indicator Maintenance
Inf ormation Indicator VTM-4 Indicator
Instrument Panel Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
77
Continuing to drive with the VTM-4
indicator blinking may cause serious
damage to the system.
10/01/26 18:36:26 31SZA620_082
2011 Pilot