FujiFilm 2400 - Manual (Page 8)

15
1
14
2
1
➀
Check that the camera is switched off and then open
the slot cover in the direction of the arrow.
➁
Push the SmartMedia firmly into the SmartMedia slot
as far as it will go.
➂
Close the slot cover.
LOADING AND REMOVING THE SmartMedia ™
SmartMedia TM Loading the SmartMedia TM
● ! If you open the slot cover while the camera is switched
on, the camera is automatically switched off to protect
the SmartMedia.
● ! The SmartMedia will not slide fully into the slot if it is
inserted facing the wrong way. Be careful not to apply
undue force to the SmartMedia.
● ! Images cannot be recorded or erased if a write-
protect sticker is affixed to the SmartMedia.
● ! Operation of this camera is only guaranteed when it
is used with Fujifilm SmartMedia.
● ! Some 3.3V SmartMedia are labelled as “3V ” cards.
■ Only use 3.3V SmartMedia.
MG-4S (4MB), MG-8S (8MB), MG-16S/SW
(16MB), MG-32S/SW (32MB), MG-64S/SW
(64MB)
Removing the SmartMedia TM
➀
Check that the viewfinder lamp is lit green
before you switch the camera off. (Set the
Mode switch to “OFF”.)
➁
Open the slot cover in the direction of the arrow.
Always switch the camera off before opening
the slot cover. Opening the slot cover while the
camera is on can corrupt the image data on
the SmartMedia card or damage the card itself.
To record data on a SmartMedia, you must
first format the SmartMedia using the
FinePix2400 ZOOM (
➡P.48).
Grip the SmartMedia and pull it out.
● ! To protect the SmartMedia, always store it in the
special anti-static case.
● ! See P.72 for more information on SmartMedia.
◆
Printing Images and Downloading
Images to a Personal Computer
◆
● See P.54, 63 for information on printing your
images.
● See P.63 to 65 for information on downloading
your images to a personal computer.
● ➀ ● ➂
● ➁
● ➀
● ➁