Mr-hd100 to wired (ethernet) network, Mr-hd100 and ftp – FOCUS Enhancements MR-HD100 User Manual
Page 164
MR-HD100 Media Recorder
144
MR-HD100 to Wired (Ethernet) Network
This procedure requires the use of a USB 2.0 to Ethernet Extender.
1.
With the MR-HD100 powered off, use an USB 2.0 to
Ethernet Extender to connect the MR-HD100 to the network.
2.
Power on the MR-HD100 and wait for the Home screen to
appear.
3.
Go to the
SETUP
menu and locate
IP ADDR
.
If the network employs DCHP, the
SETUP
options
IP ADDR
,
IP MASK
,
BROADCAST
, and
GATEWAY
display the network
assigned addresses.
4.
Open an IE or Safari web browser.
5.
Enter the MR-HD100’s
IP ADDR
into the browser’s IP
address bar and enter.
The MR-HD100
Templates
web page opens.
MR-HD100 and FTP
To access the MR-HD100 via FTP, follow the same steps above.
In Step 5, enter the address
ftp://FS:FS@
and then the
IP ADDR
from SETUP.
For more information about FTP password, see