Firstech, LLC. CM6200 - Manual (Page 26)

Copyright 2009 Firstech, LLC. Page 26
CM6200 Install Guide
Starter System
www.firstechonline.com | www.compustar.com
4-05 Secure Aux Output – On the default setting, button 4 on the remote must be pressed first before Aux 1
or Aux 2 can be triggered. This prevents accidental triggering of the outputs. Option setting II turns this
feature off.
4-06 Aux 1 Input – This option changes the input behavior of the pre-warn wire on the Aux Input Sensor
green connector.
Default 1: Will pre-warn with a negative (-) ground input.
Option 2: Will instant trigger with a negative (-) ground input.
Option 3: Will disarm the alarm with a negative (-) ground input. Used when adding an alarm to a fac
tory keyless entry system.
4-07 Aux 2 Input – This option changes the input behavior of the instant trigger wire on the Aux Input Sensor
green connector.
Default 1:. Will instant trigger with a negative (-) ground input.
Option 2: Will pre-warn with a negative (-) ground input.
Option 3: Will arm the alarm with a negative (-) ground input. Used when adding an alarm to a factory
keyless entry system.
4-08 Extended Accessory After Ignition Shutoff – This option keeps the Accessory wire powered up after the
ignition is shut off. This can be used to keep the radio turned on even after the key is removed from the
ignition (similar to GM vehicles).
4-09 Glow Plug or Key Sense – Default setting sets the wire as a glow plug input. Option setting 2 changes
the wire to a key sense input. Key sense can be used to prevent reservation mode from setting and the
system from passive arming while the key is still in the ignition. Key sense also turns off dome-light
supervision when the key is inserted into the ignition.
4-10 Trigger Start or Closed Loop System – Default setting sets the pink wire on CN3 as a trigger start
input, which will initiate remote start with a negative (-) trigger. Option 2-04 allows the number of
pulses required to initiate remote start to be changed. Setting 2 changes the wire to a closed loop
input, which makes it an instant alarm trigger when separated from ground - Ideal for protecting
trailers or headlights.
4-11 Bypass Brand Through RS232 Port – Default setting allows for compatibility with ADS Idatalink
modules. Setting 2 changes compatibility to Fortin bypass modules.