Firstech, LLC. CM6200 - Manual (Page 28)

Copyright 2009 Firstech, LLC. Page 28
CM6200 Install Guide
Starter System
www.firstechonline.com | www.compustar.com
Option Programming CM6200
Option Programming Using the OP500 (programmer)
The OP500 can be used to program any available option. It is required to program options in Special Option
Groups 1 and 2.
STEP 1: Using the blue connector on the top of the OP500, connect it to the control module via the antenna
wire. (Use the included extension cable if necessary.) Once connected, the OP500 will power up as long as the
main ignition harness to the controller has been connected properly.
STEP 2:
To change the option number you wish to program, use the left and right arrow keys on the OP500. It
will scroll through the options available in menu 1 and then move to menu 2, then 3 and 4. Use the up and down
arrow buttons on the OP500 to adjust the option settings; “1” is the default setting, and “2”, “3”, and “4” are the
optional settings.
At the end of menu 4, if diesel mode or auxiliary setting functions were enabled – or if any of the auxiliary out-
puts were set to “Program”, the duration of these settings can now be adjusted.
Following the auxiliary and diesel settings (if selected), the POC options will be displayed on the OP500. The
POCs can be set between 0 (default) and 19.
STEP 3:
When finished with the adjustment of the various option settings, press and hold the “W” (write) but-
ton until the OP500 chirps, which is approximately 2.5 seconds. This will write the settings to the control mod-
ule. Wait until the module displays “Success” before disconnecting it from the antenna cable.
To reset the options, hold the “R” (reset) button and the “W” (write) button for 2.5 seconds. Release then write
the reset, hold the “W” button until the OP500 chirps, which is approximately 2.5 seconds.
Option Programming Using a Remote
Using a remote is a timed process so read this section in its entirety before beginning. IMPORTANT: Special
Option Groups cannot be programmed with a remote – the OP500 must be used.
STEP 1: Select the option menu that contains the desired programming option.
STEP 2:
Scroll through menu allowing for 1 parking light flash and/or siren chirp per step.
STEP 3:
Once finished scrolling through the menu wait for the parking lights and/or siren chirp to confirm the
option number. i.e. option 2-04 will flash 4 times. Then use one of the table selections to select the option cor-
responding to your desired setting.
To program options use the following button combinations: