Firstech, LLC. CM6200 - Manual (Page 30)

CM6200 Install Guide
Starter System
www.firstechonline.com | www.compustar.com
Copyright 2009 Firstech, LLC. Page 30
Troubleshooting CM6200
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash two times immediately. Following those
two flashes the parking lights will flash again corresponding to the error table below:
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running or must program tach before 1st
remote start
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7
Reservation off (manual transmission only)
8 Tach or no tach sensing failure
Remote Start Shutdown Error Codes
If the vehicle shuts down after remote start sequence is initiated, the vehicle’s parking lights will flash 4 times,
pause then flash again with the error code. On 2 Way remotes tap button 4 to initiate the sequence. On 1 Way
remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of
Parking Light
Flashes
Remote Start Shutdown Error
1
Lost engine sensing signal (Tach/Alternator/Tachless)
2 Lost emergency brake signal (Manual Transmission)
3 Foot brake triggered
4 Hood pin triggered