Furuno FA-150 - Manual (Page 20)

1. OPERATION
1-9
6. Press ► to show page 3 of the NAV STATUS menu.
[ARRIVAL TIME] WX
DATE : 25/APR
TIME: 0:00
NAV STATUS menu, page 3 (date and time of arrival entry screen)
7. DATE is selected; press the ENT key.
8. Use the CursorPad to enter the date of arrival and then press the ENT key.
9. TIME is selected; press the ENT key.
10. Use the CursorPad to enter the estimated time of arrival and then press
the ENT key. Use 24-hour notation.
11. Press ► to show page 4 of the NAV STATUS menu.
[CARGO TYPE & CREW] WX
CREW: 0
TYPE NO: 00
**** TYPE DETAIL****
NOT AVAILABLE
NAV STATUS menu, page 4 (cargo type and crew entry screen)
12. CREW is selected; press the ENT key.
13. Use the CursorPad to enter number of crew (setting range: 0-8191) and
then press the ENT key.
14. TYPE NO. is selected; press the ENT key.
15. Use the CursorPad to choose type of vessel, referring to the table on the
next page, and then press the ENT key.
Note 1:
Only the second digit of the vessel class may be entered here; the
first digit is entered on the INITIAL SETTINGS menu, during
installation.
Note 2:
When “Tanker” is chosen and the Nav status is “Moored”, output
power is automatically switched to 1 W when SOG is less than 3
kts. Further, in the above condition, when SOG becomes higher
than 3 knots, the pop-up message “CHANGE NAV STATUS?”
appears and a beep sounds. (The pop-up message “TX POWER
CHANGED” also appears to notify you that the Tx power has
changed). To erase the pop-up message, press any key or lower
SOG below 3 kts.