Furuno FA-150 - Manual (Page 42)

1. OPERATION
1-31
19. LAT of RIGHT TOP is selected; press the ENT key. Use the CursorPad to
enter latitude for the right-top position (northeast point) of the AIS operating
area and then press the ENT key.
20. LON of RIGHT TOP is selected; press the ENT key. Use the CursorPad to
enter longitude for the right-top position (northeast point) of the AIS
operating area and then press the ENT key.
21. LAT of LEFT BOTTOM is selected; press the ENT key. Use the CursorPad
to enter latitude for the left-bottom position (southwest point) of the AIS
operating area and then press the ENT key.
22. LON of LEFT BOTTOM is selected; press the ENT key. Use the
CursorPad to enter longitude for the left-bottom position (southeast point)
of the AIS operating area and then press the ENT key.
Note: The available range is 20-200 nm. If the area contains overlapping
data the older data will be erased.
RIGHT-TOP
LEFT-BOTTOM
ZONE
1-8 nm
20-200 nm
20-200 nm
Description of RIGHT-TOP, LEFT-BOTTOM and ZONE items
23. Press the MENU key. The prompt shown below appears.
SAVE CHANNEL.
ARE YOU SURE?
YES
NO
24. Press ◄ to choose YES and then press the ENT key.
Note: If a combination other than that shown in the table at step 13 is
selected, the message “ILLEGAL MODE WAS SELECTED PRESS
ANY KEY.” appears.
25. Press the DISP key to close the menu.
Note: If you enter invalid data, the message “OUT OF RANGE!: OO” appears.
Press any key to escape. Reenter data.