Furuno GD-1700C - Manual (Page 191)

5. CUSTOMIZING YOUR UNIT
5-21
WAAS SETUP
Press the WAAS SETUP soft key to show the WAAS SETUP display.
Note: This function requires GP-320B antenna. Also, confirm that your display
unit has the program version no. shown below.
NavChart type: Ver.12 and after (1710C: Ver.4 and after)
C-map type: Ver.8 and after (1710C: Ver.4 and after)
Contents of WAAS SETUP menu
Item Description Settings
WAAS MODE Select ON to use the WAAS mode. On, Off
WAAS SEARCH WAAS satellite can be searched
automatically or manually. For manual
search, enter appropriate WAAS satellite
number. Auto, Manual
WAAS ALARM When the WAAS signal is lost, the audible
alarm sounds with the visual message “NO
WAAS SIGNAL.”
On: Alarm continues to sound until the WAAS
positioning mode is available again or the
alarm is recognized by key operation.
Off: Alarm sounds three times.
On, Off
CORRECTION DATA
SET Selects the type of message for WAAS
correction. Use "02 (Default Setting)" until the
WAAS System changes from its current
"Testing Status" to "Operational Status". 00 to 27, 99
Note: If the message “NO POSITION DATA!” appears, it means an error occurs
on GPS-310B/320B. Disconnect GPS cable from the display unit.