Furuno GD-1700C - Manual (Page 27)

1. OPERATIONAL OVERVIEW
1-13
1.5.4 Selecting image source
When more than one network radar or network sounder is connected to the
equipment, you may select an image source for each as shown below. This is
not necessary when only one network radar or network sounder is connected.
1. Press the [DISP] key.
2. Press any soft key to show the following display.
RADAR SOURCE
RADAR - - -
SOUNDER SOURCE
SOUNDER -
IP ADDRESS
172. 031. 014. 001
HOST NAME
PLOTTER -
▲
SELECT
SOURCE
EDIT
RETURN
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
Select source menu
3. Use the cursor pad to select RADAR SOURCE or SOUNDER SOURCE as
appropriate, then press the EDIT key.
RADAR SOURCE SOUNDER SOURCE
Radar source Sounder source
R ADAR - - - S OUNDER-
Radar source and sounder source windows
4. Use the cursor pad and [ENTER] knob to enter source name: ◄ or ► to
select position and rotate the [ENTER] knob to select character.
5. Press the ENTER soft key or [ENTER] knob.
6. Press the [DISP] key to finish.
7. Turn the power off and on again.
Note:
Source names are determined at installation. For example, the source
names for radars in a two radar system might be “RADAR” and
“RADAR1”.