Furuno GD-1700C - Manual (Page 193)

5. CUSTOMIZING YOUR UNIT
5-23
6. If necessary, you may enter a position offset to refine Loran C position
accuracy. Select (GRI) CORRECTION 1 or CORRECTION 2, then press the
EDIT soft key. Enter correction value with the cursor pad and [ENTER] knob,
then press the ENTER soft key or the [ENTER] knob. Use the +
<− −> - soft key
to switch from plus to minus and vice versa.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select “LORAN C” from “TD DISPLAY” and “TD” from “POSITION DISPLAY.”
10. Press the RETURN soft key followed by the [MENU] key twice to close the
menu.
Displaying DECCA TDs
1. Select CHAIN, then press the EDIT soft key to show the chain & station pair
window.
CHAIN STATION PAIR
S BALTIC
01 R-G
▲
▼
▼
Decca chain and station pair window
2. Use ▲ or ▼ on the cursor pad to select Decca chain number.
3. Press ► to enable selection of station pair.
CHAIN STATION PAIR
S BALTIC
R-G 01
▲
▼
▼
4. Use ▲ or ▼ on the cursor pad to select lane pair (R: red, G: green and P:
purple).
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter position offset to refine Decca position. Select
(CHAIN) CORRECTION 1 or CORRECTION 2, then press the EDIT soft key.
Enter correction value with the cursor pad and [ENTER] knob, then press the
ENTER soft key or the [ENTER] knob. Use the +
<− −> - soft key to switch from
plus to minus and vice versa.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select “DECCA” from “TD DISPLAY” and “TD” from “POSITION DISPLAY.”
10. Press the RETURN soft key.
11. Press the [MENU] key twice to close the menu.