FOCUS Enhancements TView Quad Scan Manual - Manual (Page 12)

TView QuadScan User's Manual 0092-5000-200
12
2.1 Quad Scan Desktop Version Installation
Follow these steps to install your Desktop QuadScan.
Turn all system components off.
Select a convenient location for the QuadScan.
Plug the QuadScan’s wallmount power supply into an appropriate outlet or power strip. Plug the 2.5mm connector of the
wallmount power supply into the QuadScan.
Determine the signal connections on the display device.
If the display device has BNC inputs, you will require an HD15 Male to 5 BNC Male Cable (SKU# 444-5906).
Connect the HD-15 side of this cable into the Hi-Res Output of the QuadScan. Connect the 5 wires of the BNC
Male connectors (Red, Green, Blue, H Sync and V Sync) to the appropriate BNC Female connectors of the
display device.
If the display device has a cable that terminates in an HD-15 Male connector, this device may be directly
connected to the Hi-Res Out connector of the QuadScan.
If the display device has a cable that terminates in an HD-15 Female connector, you will require an HD15 Male
to HD15 Male Cable (SKU# 444-5008). Connect one end of the HD-15 Male Connector to the Hi-Res Output
connector of the QuadScan. Connect the other end of the HD15 Male to HD15 Male Cable to the HD-15
Female input of the display device.
Determine the required signal connections for the television device(s). In all cases, it is best to connect to the QuadScan’s
Channel A connector if a second channel is not required.
Composite sources will have either RCA or BNC connections.
If the source has a BNC connector, you can connect directly to the Channel A or B NTSC/PAL IN connector
with the supplied BNC Male to BNC Male Cable.
If the source has an RCA connector, attach one of the supplied RCA Female to BNC Male adapters to the
channel A or B NTSC/PAL IN connectors. Connect the Television device to the adapter with an RCA Male to
RCA Male cable (not supplied).
S-VHS Sources are easily connected by connecting the S-VHS output of the television device to the channel A or B S-
VHS IN connector of the QuadScan.
Component sources will have either RCA or BNC connections.
If the source has BNC connectors, you will require a 5 BNC Male to 5 BNC Male Cable (SKU # 444-5914),
(actually only 3 wires of the 5 wire cable will be required). Connect the Y channel of the component source to
the QuadScan’s Channel A or B Y IN connector. Connect the R-Y (or Pr) channel of the component source to