FOCUS Enhancements TView Quad Scan Manual - Manual (Page 18)

TView QuadScan User's Manual 0092-5000-200
18
3.4 Motion Processing
3.4.1 Motion Processing (Multiple)
This control determines which type of video motion processing will be applied. The options are:
Motion Processing Mode Front Panel Designation
Auto Auto
Film Film
Motion Motion
Still Still
Film Processing (3:2 pulldown sourced material) is used to compensate for the motion artifacts of video program material
from film sources. Motion Processing is used to compensate for the motion artifacts of motion video program material
from 60 Hz. (50 Hz. PAL) video sources. Still Processing is used to deliver the highest possible resolution for still video
program material (such as the output of a document camera focussed at a page). Automatic Processing (Auto) analyzes
the incoming video program material and selects the most appropriated motion treatment from these three options. The
default Motion Processing is AUTO.
Motion Processing Selection is indicated by “DSP=” followed by the abovementioned designation on the
QuadScan’s Front Panel Display.
3.5 Signal Routing
3.5.1 Component YUV Pass Through (Toggle) (Not available from IR remote mouse)
This control determines whether the Component television input on Channel A is routed through to Channel B or not.
If the signal is “passed through” Component television that is input on Channel A will appear as an output on Channel B.
If the signal is not passed through, Channel B Component television will be configured as a second Component television
input. The default is Channel B configured as an input.
YUV Channel B Configuration is indicated by “YUV B = PASS” or “YUV B= INPUT” on the QuadScan’s Front Panel
Display.
3.5.2 S-VHS Pass Through (Toggle) (Not available from IR remote mouse)
This control determines whether the S-VHS television input on Channel A is routed through to Channel B or not.
If the signal is “passed through” S-VHS television that is input on Channel A will appear as an output on Channel B. If
the signal is not passed through, Channel B S-VHS television will be configured as a second S-VHS television input. The
default is Channel B configured as an input.
S-VHS Channel B Configuration is indicated by “SVHS B=PASS” or “SVHS B=INPUT” on the QuadScan’s Front
Panel Display.