FUJITSU MB91F109 FR30 - Manual (Page 206)

182
CHAPTER 4 BUS INTERFACE
4.17.13 DRAM Interface in High-Speed Page Mode
This section provides DRAM interface operation timing charts in high-speed page
mode.
■ DRAM Interface Timing Charts in High-Speed Page Mode
❍ Read cycle, bus width: 16 bits, access: words
Figure 4.17-25 Example 1 of DRAM Interface Timing Chart in High-Speed Page Mode
[Explanation of operation]
• Read control is performed with only the CAS control signals (including CASL and CASH)
while RAS is lowered to "L", and "H" of WE (including WEL and WEH) is held.
• Column addresses are output in Q4 and Q5 cycles.
❍ Write cycle, bus width: 16 bits, access: words
Figure 4.17-26 Example 2 of DRAM Interface Timing Chart in High-Speed Page Mode
Q1 Q2 Q3 Q4 Q5 Q4 Q5 Q4 Q5 Q4 Q5
CLK
1CAS/2WE
A24-00
X #0 row.adr. #0 col.adr #2 col.adr #4 col.adr #6 col.adr
D31-24 #0 #2 #4 #6
D23-16 #1 #3 #5 #7
RAS
CAS
WEL
WEH
RDX
1)
Usual DRAM bus cycle High-speed page High-speed page High-speed page
Q1 Q2 Q3 Q4 Q5 Q4 Q5 Q4 Q5 Q4 Q5
CLK
2CAS/1WE
A24-00
X #0 row.adr. #0 col.adr #2 col.adr #4 col.adr #6 col.adr
D31-24 #0 #2 #4 #6
D23-16 #1 #3 #5 #7
RAS
CASL
CASH
WE
RDX
2)
Usual DRAM bus cycle High-speed page High-speed page High-speed page