Frymaster FLAT BOTTOM 2424G - Manual (Page 25)

24G SERIES FLATBOTTOM GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-20
The probable causes of each category are discussed in the following sections. Troubleshooting
guides are included in Section 1.9 to assist in identifying some of the more common problems.
1.8.1 Ignition Failures
Ignition failure occurs when the ignition module fails to sense a flame within the 11-second time
delay period and locks out. Turn the fryer off, locate and correct the problem, then turn fryer back
on to clear the module lock.
There are three primary reasons for ignition failure, listed in order of probability:
1. Problems related to the gas and/or electrical power supplies.
2. Problems related to the electronic circuits.
3. Problems related to the gas valve.
Problems Related to the Gas and/or Electrical Power Supplies
The main indicator is that an entire battery of fryers fails to light. Verify that the quick disconnect
hose is properly connected, the fryer is connected to power, the main gas supply valve is open, and
the circuit breaker for the fryer electrical supply is not tripped. Some fryers are equipped with a
fryer reset-switch that must be reset each time the fryer is turned off.
Problems Related to the Electronic Circuits
If gas and electrical power are supplied to the fryer, the next most likely cause of ignition failure is a
problem in the 24 VAC circuit of fryers equipped with electronic ignition systems, or in the pilot
system for those without electronic ignition. If the fryer is equipped with an Under Fryer Filter
(UFF) filtration system, first verify that the drain valve is fully closed. (The valve is equipped with a
microswitch that must be closed for power to reach the gas valve. Often, although the valve handle
appears to be in the closed position, the microswitch is still open.) If the valve is fully closed, or the
fryer does not have a filtration system, refer to the troubleshooting guides in this chapter.
Problems Related to the Gas Valve
If the problem is not in the 24 VAC circuit or pilot system, it is most likely in the gas valve itself, but
before replacing the gas valve, refer to the troubleshooting guides in this chapter.