Fujitsu Siemens Computers Connectivity Peripherals Point 1600 - Manual (Page 22)

2-6 Assembling and Installing Connectivity Peripherals
Figure 2-5. Bottom View, Port Replicator
Connectors on the port replicator are described in Table 2-2.
* Because of its modular design, the port replicator is equipped with two mouse ports. Only
one mouse device should be connected at a time.
Table 2-2. Port Replicator Connectors
Port Description
Serial Port A This connector can be used to connect an external device with a
serial interface such as a modem. This is a fully-functional RS232-C
serial port.
Serial Port B This connector can be used to connect an external device with a
serial interface. Note the following:
1) This port provides only the Rx and Tx (receive and transmit)
signals of the RS232-C interface. 2) When this port is enabled, the
IrDA port on the pen tablet is disabled.
Parallel Port This connector can be used to connect a device with a parallel
interface such as a parallel printer.
Floppy Disk
Drive Port This connector can be used to connect the Fujitsu FMWFD2 floppy
disk drive.
Mouse Port
*
(on portable
port expander)
This connector can be used to connect a PS/2-style mouse. When
used with the Point 1600 pen tablet, this connector can be connected
to either a PS/2-style keyboard or mouse.
Video Port This connector allows you to connect an external SVGA monitor.
Point 1600 pen tablet users: Note that an external monitor and the
pen tablet display screen cannot be viewed simultaneously.
DC Input This connector can be used to connect the AC adapter or auto
adapter.
Keyboard Port This connector can be used to attach a PS/2-style keyboard.
Mouse Port
*
(on cradle
module)
This connector can be used to connect a PS/2-style mouse.
Mouse Port
Keyboard Port
DC Power
Serial Port B Parallel Port
Mouse Port (on portable port expander)
Floppy Disk
Serial Port A Video Port
Drive Port
Input Port
(on cradle module)