Fujitsu Siemens Computers Connectivity Peripherals Point 1600 - Manual (Page 32)

2-16 Assembling and Installing Connectivity Peripherals
To install the AC adapter in the cradle base,
1. Turn the cradle base upside down.
2. Detach one end of the Velcro strap and insert the AC adapter into the cavity in the bottom of the
cradle base as shown in Figure 2-11.
3. Reattach the velcro strap to secure the AC adapter.
4. Attach the DC power cable from the AC adapter to the DC input connector on the cradle module.
5. Coil the DC supply cable of the AC adapter into “figure-eight” loops as shown in Figure 2-11 and tie
the coiled cable using the tie wrap provided. Ensure that there is enough slack in the cable to allow
the cradle module to pivot to the fully tilted position.
The cradle is now ready for installation at the work site.
Figure 2-11. High-Connectivity Cradle Bottom View
Keyboard
Mouse
DC Input
Port
Port
Power Port
Serial Port B
Parallel Port
Mouse Port
Floppy Disk Port Serial Port A
Video Port
Cutouts
(for cable routing) Cutouts
(for cable routing)
Velcro
Strap
AC Adapter
AC Power Cable
Mounting Holes
(Tie excess cable here.)
Cutouts (for cable routing) Cutouts (for cable routing)