Fujitsu Siemens Computers Connectivity Peripherals Point 1600 User Manual
Page 37
Installing the Wall-Mount Cradle
2-21
Figure 2-12. Wall-Mount Cradle Mounting Plate
To install the wall-mount cradle,
1.
Attach the mounting plate to the junction box. To do so, align the square hole in the mounting plate
with the junction box and fasten the plate to the junction box. Use four screws with star-washers (not
provided) to fasten the plate to the junction box. (The star-washers are required to break through the
paint on the mounting plate and ensure that the plate is grounded to the electrical junction box.)
2.
Attach the mounting plate to the wall. The bottom two round holes should be used so that the
wall-mount cradle cannot be lifted up once installed. At least two of the four slotted holes should
also be used and properly fastened to the wall according to local building codes.
3.
Unplug the AC power cable from the AC adapter.
Mounting Holes
Mounting Holes
(To attach plate
to wall.)
(To attach plate
to wall.)
Mounting Holes
(To attach plate
to junction box.)
Mounting Holes
(To attach plate
to junction box.)