Frymaster 2836 Series - Manual (Page 21)

4-3
4.3 Operating the Filter
4.3.1 Pan Preparation
1. Disconnect the suction hose from the filter
assembly by grasping the quick-disconnect
collar on the hose and pulling it away from
the filter pan and off the quick-disconnect
fitting on the pan.
The quick-disconnect seals when
disconnected to prevent any oil leakage.
Quick-Disconnect Fitting
2. Remove the crumb screen, hold-down ring, filter paper, and filter grid from the pan. Dispose of
the filter paper, clean all other components in hot, soapy water and dry thoroughly. Clean the
pan and sump, ensuring the air hole in the pickup (suction) tube is clear of debris.
DANGER
The crumb tray in fryers equipped with a filter system must be emptied into a fireproof
container at the end of frying operations each day. Some food particles can spontaneously
combust if left soaking in certain shortening material.
3. Place the filter grid in the bottom of the pan
and lay one sheet of filter paper over the grid.
Lower the hold-down ring over the paper and
grid so that the paper folds up around the
outer edges of the ring.
Sprinkle one 8-ounce cup of filter powder
evenly over the filter paper.
Install the crumb screen, being sure that it is
positioned all the way to the front of the pan
so that the tabs on its ends engage the slots in
the filter pan.
Filter Grid Filter Paper
Hold-Down Ring
Crumb Screen