Fostex MR-8CD - Manual (Page 72)

72
MR-8HD/CD Owner’s Manual (Track bouncing)
The MR-8HD/CD can mix input signals of [ INPUT A ] through [ INPUT D ]. The following diagram
shows an example of mixing signals of INPUT A through INPUT D when bouncing tracks 1 through
6 to tracks 7/8. As you can see, the signals of INPUT A through INPUT D are mixed to the L/R
stereo buss together with the bounced signals.
Before starting track bouncing, connect the de-
sired sound source(s) to any desired input(s)
between INPUT A and INPUT D.
Connecting sound sources to INPUT A through INPUT D
Adjust the input level of each input using the
[
TRIM ] control to match the balance with the
bounced track levels.
Also, you can adjust panning of each input for
stereo mix. See the next page for details about
how to set panning.
To mix the input signal of an input channel (any
of INPUT A through INPUT D) to the L/R stereo
buss, turn on the corresponding [
TO STEREO
BUSS ON/OFF ] key.
[TO STEREO BUSS ON/OFF] key setting
MIN MAX LINE MIC LINE MIC LINE MIC LINE MIC
BAL BAL BAL
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK PEAK
DISTORTION
GUITAR
/GUITAR
INPUT A SELECT
INSERT
BAL
UNBAL
TRIM
INPUT A INPUT B INPUT C INPUT D
ON/
OFF
TO STEREO BUSS
ON/
OFF ON/
OFF ON/
OFF
[TRIM] control
MIN MAX LINE MIC LINE MIC LINE MIC LINE MIC
BAL BAL BAL
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK PEAK
DISTORTION
GUITAR
/GUITAR
INPUT A SELECT
INSERT
BAL
UNBAL
TRIM
INPUT A INPUT B INPUT C INPUT D
ON/
OFF
TO STEREO BUSS
ON/
OFF ON/
OFF ON/
OFF
[TO STEREO BUSS ON/OFF] key
When the [ TO STEREO BUSS ON/OFF ] key is
turned on, the key illuminates in green. That is,
when the key illuminates, input signal is sent to
recording tracks. (Note that when the key
flashes, the corresponding input is assigned to
any recording track.)
Trk 4
Trk 3
Trk 2
Trk 1
Mastering Ef
fects
Trk 5
Trk 6
Mixing
Playback
Reverb
or
DElay
Bouncing
Trk 7
Trk 8
STEREO OUT (L, R)
INPUT A
INPUT B
INPUT C
INPUT D
TRIM
Playback
Playback
Playback
Playback
Playback
Record
Record
<Note>: If you press the [TO STEREO BUSS ON/OFF] key when make recording other than track bouncing, the
key lamp may flash. This shows the input signal is routed to the armed track. That is, the input signal will be
recorded to the armed track, in stead of mixed to the stereo buss.
Mixing signals of inputs A through D
Sound source (s)