Fisher & Paykel OR60 - Manual (Page 18)

16
Installation instructions
FOUR FUNC
TION MODELS
CER
AMIC GLASS C
OOK
T
OP MODELS
Levelling the cooker
Important!
Using the supplied adjustable feet is MANDATORY.
For safety reasons and to ensure adequate
ventilation, the cooker chassis MUST NOT sit directly
on the floor, a plinth, or other support surface.
To fit the adjustable feet:
1 Rest the rear of the cooker on a piece of
packaging, exposing the base for fitting the feet.
2 Screw the four feet to the cooker.
3 Stand the cooker and level it by screwing or
unscrewing the feet with an adjustable spanner.
Use the supplied nuts if necessary. See Figs. 16a-
16d.
Fixing the backguard
Before installing the cooker, assemble the
backguard “B” .
The backguard “B” can be found packed at the
rear of the cooker.
1 Before assembling, remove any protective film/
adhesive tape.
2 Remove the three screws “A” from the rear of the
cooktop.
3 Assemble the backguard as shown and fix it by
screwing the three screws “A”.
Fig. 17 Assembling the backguard
A
A
B
Fig. 16a Fitting the
adjustable feet
(supplied with the cooker
in the feet kit)
0
+ 8 mm
+ 8 mm
+ 15 mm
Fig. 16d Levelling the cooker
Fig. 16b Do not use the supplied nuts for height
adjustments between 0 and 8 mm.
Fig. 16c Use the supplied nuts for height
adjustments between 8 and 15 mm.