Fisher & Paykel OR60 - Manual (Page 48)

46
Care and cleaning
FOUR FUNC
TION MODELS
SE
VEN-FUNC
TION MODELS
WITH GAS C
OOK
T
O
P
Burner parts and trivets
You can remove and clean these parts with hot soapy water or non-abrasive detergents.
Clean spills regularly before they become burnt on. Do not wash these parts in a
dishwasher.
After cleaning, check that the burners and their flame spreaders are dry before replacing
correctly.
It is very important to check that the burner flame spreader and the cap have been
correctly positioned. Failure to do so can cause serious problems.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all
burner parts in place.
Replacing the auxiliary and semi-rapid burners
Carefully replace the burner parts as per the following Figs.
Check that:
The ignitor is always clean to ensure trouble-free sparking.
The probe is always clean to ensure correct operation of the safety valves.
Note: both the ignitor and probe must be very carefully cleaned using a toothbrush and
methylated spirits (see Fig. 46).
Fig. 49 Correct line-up of the auxiliary and semi-
rapid burner parts
Fig. 50 Replacing the auxiliary and
semi-rapid burner caps
Cap
Flame
spreader
Ignitor
Flame failure probe