FUJITSU Primecenter M1 BS2000 - Manual (Page 38)

38
Support systems
©
c
o g n
it as
. Ges
e
lls
c h
ft f ü
r T
e c hni
k -D
o k
u m
e n
tat
ion m
b H 20
11
P
fa
d : O
:\ F
T
S
\P
RI
M
E
R
G
Y
-HW
\R
a c k \P
C
R
-M
1
-R
ac
k \M
anua
ls
\U
s e r M
anu
al
\0
2
_ wo
rk
\pc
r-
m
1 -r
ac
k -u
m
-en
\pc
rm
1-
rac
k -u
m
-e
n .k
0 5
5.1 Support Systems
Support systems are needed in order to be able to integrate system
components effortlessly into the rack. The PRIMECENTER M1 19-inch rack
supports all support systems with a depth of 740 mm that correspond to
industry standards EIA-310-D, DIN41494 and IEC60297 (see the configurator
at:
http://configurator.ts.fujitsu.com/public/public_en.html )
I
The mounting description of the specific support system is part of the
delivery of the specific Rack Mount Kit. Please refer to this description.
You can also find this description on the Web:
http://manuals.ts.fujitsu.com/index.php?id=5406-5605-5606
5.2 Mounting in the front 19-inch area
Introduction
Components are mounted in the front 19-inch area of the PRIMECENTER M1
19-inch rack using either telescopic rails or rails with L-brackets. Light weight
components can also be mounted via the front panel (e.g. switches, which can
be installed with screws on the front support uprights).
If components are mounted using telescopic rails, all the cables leading to the
components are routed to the component's rear side via a cable management
for 19-inch DC-PC-racks. If service work needs to be performed, the cables can
remain connected when the components are removed from the
PRIMECENTER M1 19-inch rack. This makes servicing much easier and also
allows device components in hot-plug slots to be replaced during operation.
If components are mounted using rails with L-brackets, all the cables are routed
directly to the components and are connected without any special aids, i.e.
without using a cable management for 19-inch DC-PC-racks. If service work
needs to be performed, all connected cables must be disconnected before the
components can be removed from the PRIMECENTER M1 19-inch rack.