User set parameters – Faber Genie M1600 User Manual
Page 37
Genie Monochrome Series-GigE Vision Camera
Operational Reference • 35
User Set Parameters
Parameter
Description
Frame Rate (in Hz)
Specifies the internal trigger frame rate for free run mode, in Hz.
Possible values range from 0.1 to 64.0 Hz for Genie M640 in full scan mode.
(Note: the Sapera SDK specifies the frame rate in milliHertz).
The maximum frame rate increases by using binning (see below) or partial scan (see
"
" on page 37
).
Gain (in dB)
Specifies the sensor analog Gain factor, in dB. Possible values range from
–6.0 to 12.0 dB, in 0.1 dB increments. For more information, see
" on page 36
.
Black level (in 1/16 DN)
Specifies the sensor black level, in 1/16 DN (digital number, which is the value assigned to a
pixel in a digital image). Possible values range from -128 to 127.
Binning Horizontal
Enables or disables horizontal binning. Possible values are Disabled or 2 pixels. When set to 2
pixels, the image buffer width parameter is automatically adjusted. For more information, see
"
.
Binning Vertical
Enables or disables the vertical binning. Possible values are Disabled or 2 lines. When set to 2
lines, the image buffer height parameter is automatically adjusted. The maximum frame rate
also increases.
Test Image Selector
Specifies the test image. Possible values are:
Off
Grey Horizontal Ramp
Grey Vertical Ramp
Grey Diagonal Ramp Moving
Purity
For more information, see
"
.
Exposure Control
Click Setting to open the Exposure Control dialog. For more information, see
" on page 43
.